FUTABA 8FG - Butterfly (Glid Only, Normal Wing 2-AIL and Up, Flying Wing 2-AIL+1 FLP and Up)

92
<Model Menu (Airplane/Glider Functions)>
●Selectthefunction name
and return to the Model
menu by touching the
RTN button.
<SensorTouch™>
BUTTERFLY
[Corresponding model type]: Glider, Normal: 2 ailerons or more
Flying:2ailerons+1apormore
This function is utilized to quickly slow the
aircraft and reduce altitude by simultaneously
raising the left and right ailerons and lowering the
aps (camber ap, brake ap).
Butterfly (Crow) produces an extremely
efcient landing conguration by accomplishing
the following:
1. Slow the aircraft’s velocity.
2. Provide washout at the wing tips to reduce
the tendency to tip stall.
3. Create more lift toward the center of the
wingallowingittoyataslowerspeed
● Mixing during flight can be turned ON/OFF by
setting a switch. (Always ON at [--] setting)
● The point at whi ch the  butterfly  operation
reference point can be offset.
● The operational speed of the ailerons andflaps
can be adjusted.
●Thedifferentialratecanbeadjusted.
*For a description of the setting method, see the aileron
differential function.
●Butteryoperationreferencepoint
●Select[BUTTERFLY]attheModelmenu
and access the setup screen shown
below by touching the RTN button.
*The display screen is an example. The actual
screen depends on the model type.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
(Currently selected condition name)
●Servospeedsetting
●Elevatorrate
adjustment
●Aileron/aprate
adjustment