Up/Down timer (ST1, ST2)
• Timer is displayed here.
Touch the RTN button at the [xx]:[xx.x]
item to start/stop the timer.
• Use the cursor to highlight this, then
touch the RTN button at the ST1 or ST2
item to call the timer set-up screen.
*See the description at the back of this manual.
Warning
Be sure to confirm the model name before flying
your aircraft.
Check the battery voltage as often as possible and
try to charge the battery earlier. If the battery alarm
makes a sound, land your aircraft immediately.
*You can adjust the LCD contrast by the display setting in the
System menu.
Home screen
Digital trim (T1 to T4)
• Trim position is displayed here.
• You can select the display unit
on the home screen on the
T1-T4 setting screen within the
linkage menu.
Model Name
• The model name
that is currently
used is displayed
here.
• U se t h e c u r s or
to highlight this,
then touch the
RTN button to call
User's name
System timer
• This shows the accumulated time since
the latest reset. (Hour):(Minute)
• Use the cursor to highlight this, then
touch the RTN button for one second
to reset the system timer.
Use the touch sensor to select the following display area to call each setting screen, and touch the RTN
button. The setting screen appears.
RF indicator
Battery Indicator
• When the battery voltage
reaches 6.8V, the alarm will
beep. Land your aircraft
immediately.
FASST mode
• FASST mode is displayed here.
• Use the cursor to highlight this,
then touch the RTN b utt on
to call the frequency set-up
screen.
2
nd
Home screen
• Touch the RTN button at
the clock icon to call the
2
nd
home screen (large
size timer).
Model timer
• This shows the accumulated time
since the latest reset. (each model)
(Hour):(Minute)
• Use the cursor to highlight this,
then touch the RTN button for one
second to reset the model timer.
Key lock
• Touch the S1 button for one second
to lock/unlock the key operation.
In the key lock mode the key icon is
displayed here.
Model type
SD card indicator
Condition name (Heli/Glider)
• In the normal condition, move the
cursor to the condition name and
touch the RTN button. The condition
name is changed and blinked.
I t i s p o s s i b l e t o o p e r a t e t h e
digital trim other than the normal
condition.
To Next Page
Loading...
