FUTABA 8FG - Dual Rate

72
<Model Menu (Common Functions)>
●Selectthefunction name
and return to the Model
menu by touching the
RTN button.
<SensorTouch™>
DUAL RATE
The angle and curve of each stick function can be set. [All model types]
Dual rate function is used to adjust the amount
of throw and the operational curve of the stick
functions (aileron, elevator and rudder) for each
ight condition or up to 5 rates for each function.
For airplane type, it is also possible to adjust the
operational curve of the throttle function.
This is normally used after the End Point
programming has been completed to define the
maximum throw. When mixing is applied from one
channel to another channel, both channels can be
adjusted at the same time by adjusting the operation
rate through the dual rate function.
●Select[DUALRATE]attheModelmenuandaccess
the setup screen shown below by touching the
RTN button.
(Currently selected circuit #)
●Functionselection
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
●Left/right(up/down)rate
●Operationcurve(left/right,up/down)
●Switchselection
[Airplane]
[Helicopter/glider]
●Switchmode
selection
●Conditionselection
●Switchselection
*Up to ve rates for each function