Manual Introductory Section
USING YOUR FUTABA SYSTEM
This section contains information on charging the batteries in your
system, and installing the airborne components in your model. We will
also tell you all the ways that you may customize your PCM 1024Z
System mechanically, so it "feels right" in your hands.
Then, we will show you all the features that are used by all the
model types that may be controlled by the PCM 1024Z system. This
will include all the exclusive PCM 1024Z features, including timers,
trim settings, voltmeter with load, direct-servo connect, and trainer
systems.
Using Your Futaba System: Contents
Radio
Installation
................................
17
Charging & Direct Servo Connect Operation .............. 18
Stick Length Adjustment ........................... 19
Stick Tension Adjustment .......................... 19
Stick
angle
adjustment
.............................
20
Antenna Angle Adjustment
.........................
20
Rubber Protective Pad Installation ..................... 21
Transmitter Battery
Replacement
.....................
21
Transmitter
RF
Module
............................
22
Optional Synthesized Frequency Module & Receiver
(see caution message) ............................. 22
Flight
Condition
Switching
..........................
23
Manual Introductory Section, Page 16
To Next Page
Loading...
Need help?
General
