Model Setting Section
TIM—TIMERS & ELAPSED TIME COUNTER
The Timer function may be set for any desired
time, i.e. engine run time, specified times for com-
petitions, etc. Two independent timers are provid-
ed for your use. The timers are stored indepen-
dently with each model, meaning that when you
switch between model setups, the timer associated
with the new model is brought up automatically.
The timers may be set to start and stop from
the soft keys, or from the motion of any switch or
stick. You may set the ON and OFF directions
freely. Each timer has a capacity of up to 59
minutes 59 seconds. You may set the timer from
either the Home Display or the Model Menu, using
the
TIM
key.
Each timer may be set for countdown or count-
up operation with a target time. If a target time is
set and the timer reaches the set time, a buzzer
sound for each count is generated. Countdown
timers sound two short beeps during the last ten
seconds before reaching the target, then a long
tone at the target time, and continue counting
while displaying a minus (-) sign. Count up timers
also beep the last ten seconds, beep the target
time, and keep counting upwards until shut down.
Setting Up Timers
To select the timer you wish to set, use the
SEL
(
R
) button. This key toggles between the two timers,
Next, choose either an up or down timer using the UP
and
DWN
(
L
and
M)
keys.
Set your desired target time by pressing the
SET
(
G
) key. This calls up the timer-setting keys on the
screen bottom. You may input the desired number of
minutes by pressing any of the number keys, then adjust-
ing with the + (F) and - (G) keys. To adjust the
seconds value, press the minute/second M/S (
E
) key
once. To get back to the minute setting, press M/S
again.
The timer you have just set will now work on the
start/stop (S/S) keys (B and D). If you'd like to
have a switch or stick position turn them on and off, press
the
SWT
key (P) now. Then use either the switch
setting or stick setting menu to set the desired switch or
stick (for more info, see page 37).
You may choose whether Timer 2 is displayed on the
home screen. To display it, press the
DSP
(
J
) key.
The Timer 2 display is turned on and off alternately as
this key is pressed.
When you are satisfied with all the timer setups, press
the
END (N)
key to return to the home menu.
Timer Operations
To start and stop Timers 1 and 2, press the S/S keys
(A
and D respectively). Each time the Start/Stop key is
pressed, the timer stops (if running) or starts (if stopped).
To reset the two timers, press the
RST
keys (
B
and
C).
Model Setting Section, Page 41
To Next Page
Loading...
Need help?
General
