System Section
MS L—MODEL SELECTION
This function is used to load the settings of the
desired model into the PCM 1024Z's memory. The
settings may be selected from either the trans-
mitter's built-in memories, or from an optional
CAMPac. Remember that up to 10 memories are
available in the transmitter, and as many as 16 may
be stored in the CAMPac. The CAMPac is not
loaded with default models initially; they must be
loaded with the Copy Model [CPM] function.
Model Memory Selection Keys
Selected Model
No. and Name
Transmitter Model Memory List
Active Model No. and Name
END returns to
System Menu
To load a desired model from internal transmitter
memory to the active area:
1. Select the desired model number with the A to J
( 1 to 1 0 ) keys
2. Press the L ( YES ) key if correct, otherwise use the
M ( NO ) key to start over. Verify that the chosen
model number and name is now shown in the display's
top center.
3. Finish by pressing the N ( END ) key.
To load a desired model from CAMPac memory
module to the active area:
1. Press the P (
NXT
) key to display the first ten
models in the memory module's contents. Press it
again to get the remaining models. To return to the
previous model list, press (
PRE
). Select the
desired model number with the
A
to J (11 to 20 or
21 to 26 ) keys.
2. Press the L ( YES ) key if correct, otherwise use the
M ( NO ) key to start over. Verify that the chosen
model number and name is now shown in the display's
top center.
3. Finish by pressing the N ( END ) key.
To DELETE a desired model from CAMPac mem-
ory module:
1. Press the P (
NXT
) key to display the first ten
models in the memory module's contents. Press it
again to get the remaining models. To return to the
previous model list, press (
PRE
). Select the
desired model number with the A to J ( 11 to 20 or
21to 26 ) keys.
2. Press the L (
YES
) key if correct, otherwise use the
R( DEL ) key to start over. Verify that the chosen
model number and name is now shown in the display's
top center.
3. Press the R (
DEL
) key.
4. If this is the correct model to delete, press the
L (
YES
) key. To choose another, press the M
(
NO
)
key.
5. Verify the deletion from the model list. Then, exit by
pressing the
N
(
END
) key.
System Section, Page 25
To Next Page
Loading...
Need help?
General
