Model Setting Section
PIT—PITCH CURVE
The Pitch Curve function applies only to Heli-
copters. Its purpose is to select whether the pitch
curve function is to be used with the active model.
The pitch curve divides the full travel of the
stick into twelve segments separated by thirteen
points. The location of these points may be set
with the PCV key in the Condition menu.
Pitch Curve Activation Procedure
In
the
Model
Menu,
press
the PIT
key
to
get
the
Pitch Curve Activation menu.
Return to Model
Menu
Activate/Inhibit Keys
Pitch Curve Mode
Setting Button
Use the ACT ( F ) key to activate the curve setting.
and
use the INH (G) key
to
deactivate
the
curve.
End setting by pressing the
END
(N) key.
Model Setting Section, Page 58
To Next Page
Loading...
Need help?
General
