Manual Introductory Section
TRANSMITTER BATTERY REPLACEMENT
Battery Cover
RUBBER PROTECTIVE PAD INSTALLATION
The transmitter battery is easily removed and
replaced, making it simple to have a spare battery
pack for extended flying duration.
Open the battery cover and remove the re-
chargeable battery pack by pulling outward on the
ribbon. Be careful not to damage the battery cover
or drop the battery pack.
We recommend that rubber protection pads be
installed in case the transmitter is ever rested on its
back.
Double-sided tape
Stick the double-sided
tape to the inside of the
protection pad
Repeat for other side.
Stick the protection pads to the
shaded area of the transmitter.
RF Module
Manual Introductory Section, Page 21
To Next Page
Loading...
Need help?
General
