Model Setting Section
PMD—PULSE MODE
(SWITCHING
FM/PCM)
The PMD function allows you to select the
transmission
mode
that
your
PCM
1024Z
uses.
You may select between PCM (Pulse Code Modula-
tion) and PPM (Pulse Position Modulation, also
commonly called FM). Of course, the choice
depends on the type of receiver being used. If you
change the mode of transmission, you need to
cycle the power switch Off and the On before it
will operate in the chosen mode.
Transmission Setting Procedure
In the Model Menu, press the Pulse Mode key (PMD)
to get the Pulse Mode menu shown below.
Currently Active Transmission Mode
Chosen Transmission
Mode
Return to Model
Menu
Transmission Mode Selection keys
Now, simply select the desired mode by pressing either
the
PCM
key (F) or the
PPM (G)
keys. Press the
END
(
N
) key to leave the PMD command. To operate
the transmitter in the new mode, turn power off and then
on again.
Model Setting Section, Page 43
To Next Page
Loading...
Need help?
General
