Model Setting Section
THR—THROTTLE CURVE
The Throttle Curve function applies only to
Airplanes and Helicopters. Its purpose is to select
whether the throttle curve function is to be used
with the active model.
The throttle curve divides the full travel of the
throttle
stick
into
twelve segments separated
by
thirteen points. The location of these points may
be set with the TCV key in the Condition menu.
Throttle Curve Activation Procedure
In the Model Menu, press the
THR
key to get the
Throttle Curve Activation menu.
Throttle Curve Mode
Setting Button-
Return to Model
Menu
Activate/Inhibit Keys
Use the ACT (F) key to activate the curve setting,
and
use
the INH
(G)
key
to
deactivate
the curve.
End setting by pressing the END ( M ) key.
Model Setting Section, Page 53
To Next Page
Loading...
Need help?
General
