System Section
UNA—USER NAME REGISTRATION
This function allows the user to enter his name,
up
to
ten
characters
long,
into
a
memory.
The
entered name is displayed on the top left corner of
the Home and menu screens of the transmitter.
Additionally, a special password feature allows
the user to define a four-digit password to protect
the model memory contents. Without entering the
correct password, model setups may not be
changed or entered. A second password may be
defined to protect the username entry only.
Unless you really need to, we recommend
against using the passwords. If the password is
forgotten, you will be unable to make any changes
to
your
system,
and
you'll
have
to
return
the
unit
to Futaba to be reset.
Registering a User Name
To register the desired User Name, you must do the
following: first, press the A arrow key to select the reg-
istration function. If necessary, move the cursor to the
beginning of the username with the G and I keys (left-
and right-arrow).
Select
the line
containing
the
desired character
with
the O to R keys. Now, use the K and M keys to move
across the line until the cursor is underneath the desired
character. To enter the character into the User Name line.
press the
ENT H
key. Repeat this procedure for the
remaining characters of the desired name. To make cor-
ections to entered characters, use the G and I keys to
move to the character to be changed, and enter a new
one.
When the name entry is completed, press the END
N
key.
Registering a User ID Number
Press the C key to begin the User ID Registration
function. To enter a System Password, choose the SYSG
key. To enter
a
Username password,
press
the NAME I
key.
Select the User ID Registration function by pressing
the B key. Then, move the cursor to the beginning of the
User ID line with the left- and right-arrow keys
(G)
and
I). Select the line containing the desired character with
the O to R keys. Now, use the K and
M
keys to move
across the line until the cursor is underneath the desired
character. To enter the character into the User Name line,
press the
SET H
key. Repeat this procedure for the
remaining characters of the desired name. When the
registration is complete, press the
SET
E key. then use
the END (N) key to exit.
Operating a Transmitter With User ID Registered
Turn
on the power switch, then
press the CNT K
key to get the user ID setting screen. Now you must enter
the User ID. Select the line containing the correct ID
character with the O to R keys. Next, use the
K
and
El keys to move across the line until the cursor is under-
neath the desired character. Press the
ENT
H key to
enter the character. Repeat this procedure for the remain-
ing characters of the User ID. When the registration is
complete, press the SET
E
key, then use the
END
(N) key to exit.
To Reset a System ID Number
First, you must use the procedure given in the previous
paragraph to get in, except do not exit. You will instead
reset the ID number to 0000 (four zeroes). Move the
cursor to the zero (0, not 0) key, then press the ENT
H key four times to enter "OOOO." Press the SET E-key, and exit with the END N key.
To Reset a Username ID Number
First, you must call the Username ID setting screen.
Enter all the registered characters as described before,
and press the END N key. Move the cursor to the
zero (0. not O ) key. then press the
ENT H
key four
times to enter "0000." Press the SET E key.
System Section, Page 34
To Next Page
Loading...
Need help?
General
