Model Setting Section
MNA— MODEL NAME DEFINITION
This function may be used to input or change
the name of the model in active memory. This can
be very useful to tell different models settings
apart. Each model name can be as long as eight
characters, and the model name always appears in
the top center of the display screen.
Registering a Model Name
To register the desired Model Name. press the
MNA
key from the Model Menu to enter the naming function
as shown below.
Active Model Name
Model Name
Cursor
Use to Select Character in Line
Choose Desired
Character
Desired Character
Line Selection
Return to System Menu
Use To Input Desired Character Select Character Location Keys
Press the
A
arrow key to select the registration func-
tion. If necessary, move the cursor to the desired location
within the Model Name with the G and I keys (left-
and right-arrow).
Select the line containing the desired character with
the
O to R
keys. Now, use the K and
M
keys to move
across the line until the cursor is underneath the desired
character. To enter the character into the Model Name
line, press the
ENT
H key. Repeat this procedure for
the remaining characters of the desired name. To make
corrections to entered characters, use the G and I keys
to move to the character to be changed, and enter a new
one.
When the name entry is completed, press the END
N key.
Model Setting Section, Page 51
To Next Page
Loading...
Need help?
General
