Model Setting Section
Swash Plate Selection Procedure
In the Model Menu, press the
SWH
key to get the
Swash Plate Selection menu.
Return to
Model
Menu
Type Selection Keys
Use the (
A
) key to activate the selection menu, then
use the E to D type selection keys to choose the type
matched to your model. If the selection is OK, press the
YES
(
E
) key, otherwise press the NO (F) key
and choose again.
Rate Setting Procedure
To set the aileron rate. press the B right-arrow key
and use the rate-setting keys E toM. The number keys
( 0 ) through (
100
) input the value directly. The
( + ) and ( - ) keys increase or decrease the value by 1.
The +/- may be used to reverse the offset direc-
tion. The default value is 50%, but the setting may vary
between -100 to +100%.
Repeat the rate setting procedure for Elevator by
using the C key, then set the Pitch rate using the D key.
End setting by pressing the
END (N)
key.
Model Setting Section, Page 55
To Next Page
Loading...
Need help?
General
