Common Condition Section
Mode selection Linear Mode Mixing
Press
the Mode Selection
A
key. then
press
the
NXT
To
set
the
linear
mode, do the following:
press
the A
L key to get to the mode setting menu. To choose the key, then press the LIN H key. This automatically
EXP1 mode, press the EX1 I key. If you want the sets the side A and side B rate curves to —16%, to ap-
EXP2 mode, press the EX2 J key. proximate linear response.
Side A curve rate setting Ending
Set the rate as described earlier. If you need to change Press the
the polarity of the exponential response, use the +/- menu.
F key
Side L rate setting
Set the rate as described earlier. Note this setting is
not available for EXP2 mixing.
END N
key to exit to the Condition
Common Conditions Section, Page 63
To Next Page
Loading...
