160
<Data>
Logic switch
In the Logic screen, the switch selection buttons appear on both the left and right side of the display.
(Logic switch setting screen)
1.The logic selection dialogue appears when
you push the logic mode button. The 3 types
selected.
Logic combination table:
SWITCH
SW1 SW2
off off off off off
off on off on on
on off off on on
on on on on off
2. The left and right side of the switch mode
can be set to the logic switch mode as well.
In this case, a maximum of 4 switches can
be assigned to the logic switch. The left and
off status determined by the 4 switches'
combination.
In the above case, the two switches in the
two switches in the right are calculated as
Caution:
condition select and 8 for the mixing on/off selection on each
flight condition. The error message will appear when the
exceeded logic switch is going to be selected. In this case,
switch.
2. The mixing on/off switch modes are automatically assigned
by single mode, not supported the group mode.
Assigned to single mode
To Next Page
Loading...
Need help?
General
