FUTABA T18SZ - Page 101

101
＜ Linkagemenu ＞
Altitude
Asetupofthealtitude
onwhichthealarm
operates.
↑ Anupwardarrow
indicatesthealarm
willsoundwhenthe
altitudereachesabove
yoursetvalue.
↓ Adownwardarrow
indicatesthealarm
willsoundwhenthe
altitudereachesbelow
yoursetvalue.
Alarmischosenfrom
Buzzer,Voice,and
Inhibit.
TheON/OFFswitch
ofSpeechischosen.
TheON/OFFswitch
ofmelodyischosen.
ŏ Tap the [Altitude] button in the Telemetry screen to
call the setup screen shown below.
Max.andmin.values
sincethepower
wasturnedONwill
display.
,WFDQQRWEHXVHGLQ)$667PRGHDQG6)+66PRGH
2QO\UHFHLYHUYROWDJHDQG(;7YROWDJHFDQEHXVHGLQ
)$667HVW&+PRGH
7KH)$667HVW&+7)+66PRGHFDQXVHDOOWKHWHOHPHWU\
IXQFWLRQV
Type1
Type2
Type3
"Vibrator"type
Ifthefollowingtypesareselected,thetransmitter
willvibrateduringthewarning.
Telemetry:Altitude
Displaying data from the altitude
$OWLWXGHLVDVFUHHQZKLFKGLVSOD\VVHWVXSWKHDOWLWXGH
LQIRUPDWLRQIURPDQRSWLRQDODOWLWXGHVHQVRURU*36VHQVRU
7KHDOWLWXGHRIWKHPRGHOZKLFKLVÀ\LQJFDQEHNQRZQ,ILW
EHFRPHVKLJKHUORZWKDQSUHVHWDOWLWXGH\RXFDQEHWROGE\
DODUP:DUQLQJE\YLEUDWLRQFDQDOVREHFKRVHQ'DWDZKHQ
DSRZHUVXSSO\LVWXUQHGRQVKDOOEHPDQGLWGLVSOD\VWKH
DOWLWXGHZKLFKFKDQJHGIURPWKHUH(YHQLIWKHDOWLWXGHRIDQ
DLU¿HOGLVKLJKWKDWVKDOOEHPDQGWKHDOWLWXGHGLIIHUHQFH
IURPDQDLUILHOGLVGLVSOD\HG7KLVVHQVRUFDOFXODWHVWKH
DOWLWXGHIURPDWPRVSKHULFSUHVVXUH$WPRVSKHULFSUHVVXUH
ZLOOJHWORZHUDV\RXJRXSLQDOWLWXGH8VLQJWKLVWKH
VHQVRUZLOOHVWLPDWHWKHDOWLWXGH3OHDVHXQGHUVWDQGWKDWDQ
H[DFWDGYDQFHGGLVSOD\FDQQRWEHSHUIRUPHGLIDWPRVSKHULF
SUHVVXUHFKDQJHVLQDZHDWKHUVLWXDWLRQ
First, the set of a reference is required.
1. The model and transmitter to which the
altitude sensor was connected are turned on.
2. Tap to the [Preset] of "Reference" item.
$WPRVSKHULFSUHVVXUHLVFKDQJHGDFFRUGLQJWRWKHZHDWKHU
DOVRDWWKHVDPHDLU¿HOG<RXVKRXOGSUHVHWEHIRUHDÀLJKW
Alarm set : Altitude
1. Tap Alarm and choose from Bu]]er, Voice,
and Inhibit.
2. When not operating vibrator, it is
"
Vibrator" to
Inhibit. Type1-3 will be chosen if it is made to
operate.
3. Tap to the Limit [xxx
m
] item .
4. Adjust the rate by "ʈʈ" "ʈ" "ʆ" "ʆʆ" button.
Initial value: Ń200m Ņ-50m
Adjustment range -500m~+3,000m
(ŃLimit
≧
ŅLimit)
:KHQWKHVFUHHQLVWDSSHGIRURQHVHFRQGWKHUDWHLVUHVHW
WRWKHLQLWLDOYDOXH
5. To terminate the input and return to the
original state, push the HOME/EXIT button.
*AnaltitudesensororGPSsensormustbeinstalledintheaircraft.
● IfthisissettoMode1-4,
ariseanddivearetold
byadifferentmelody.
Mode1:Littlerise/dive
→ Melodychanges
:sensitively
Mode4:Bigrise/dive
→ Melodychanges
:insensible
ŏReturn to
Linkage menu