FUTABA T18SZ - Flap Setting

129
＜ Modelmenu(Airplane/Glider/MulticopterFunctions) ＞
FLP2
(CamberFlap)
FLP1
(CamberFlap)
FLP3
(BrakeFlap)
FLP4
(BrakeFlap)
Flapsetting
[Corresponding model type]: Airplane/
glider, 2 Áaps or more]
The up/down travel of each flap (camber flaps:
FLP1/2, brake flaps: FLP3/4) can be adjusted
independently at each servo according to the wing type.
ŏ The operation reference point of each Áap can be
offset
7KHFDPEHUÀDSVRIDÀDSPRGHOFDQEHPL[HG
ZLWKWKHEUDNHÀDSV%UDNH)/3WRFDPEHU)/3
ŏ An ON/OFF switch can be set.
Setting method
ŏ Tap Áap (FLP) 1~4 up or down according to
the wing type.
Adjust the travel independently.
ŏ To offset the operation reference point of
each Áap, tap the corresponding offset item.
Use the "ʈʈ" "ʈ" "ʆ" "ʆʆ" button offset the
reference point.
ŏ When using brake FLP to camber FLP mixing,
tap the [INH] item and tap the screen. (ON is
displayed.)
When setting a switch, tap the [--] item of
the switch and tap the screen to call the
selection screen. Then, select the switch and
set its ON direction. (Always ON at "--" setting)
(For a description of the switch selection
method, see the description at the back of
this manual.)
Camberflapsetting Brakeflapsetting
ŏ Select [Flap setting] at the model menu and
call the setup screen shown below.
*Thedisplayscreenisan
example.Theactualscreen
dependsontheModel
Type.
Conditiongroup/single
modeselection(Gr./Sngl)
(Formoreinformation,see
thedescriptionattheback
ofthismanual.)
Currentlyselectedconditionname
BrakeflaptoCamberflapsetting
Operationreference
pointoffset
Operationreference
pointoffset
Upside/Downside
adjustment
Upside/Downside
adjustment
TheON/OFFswitchof
mixingischosen.
Mixing
INH ⇔ ON
Operationisperformedviathevolume
switches,etc.,setforeachflapcontrolofthe
function.
Theoperationalvolume
switchissetupby"Function"
ŏReturn to Model menu