FUTABA T18SZ - Data Reset

118
＜ Linkagemenu ＞
Datareset
Model memory setting data reset. (by item)
7KLVIXQFWLRQLVGHVLJQHGWRDOORZ\RXWRUHVHW
VHOHFWHGSRUWLRQVRUDOORIWKHVHWWLQJVVDYHGLQ
WKHDFWLYHPRGHOPHPRU\<RXPD\LQGLYLGXDOO\
FKRRVHWRUHVHWWKHIROORZLQJVHWVRIGDWD
T1~T6 (All condition):
5HVHWWKHGLJLWDOWULPVHWWLQJ
$OOWKHFRQGLWLRQVRUWKHFRQGLWLRQFXUUHQWO\EHLQJGLVSOD\HG
WKHHQWLUHJURXSIRUJURXSVHWWLQJFDQEHVHOHFWHG
7KHWULPVWHSDPRXQWDQGWULPUDWHDUHQRWUHVHW
T1~T6 (Current and Group condition):
5HVHWWKHGLJLWDOWULPVHWWLQJ
&XUUHQWFRQGLWLRQJURXSFRQGLWLRQFDQEHVHOHFWHG
7KHWULPVWHSDPRXQWDQGWULPUDWHDUHQRWUHVHW
Data resetting method
1. Tap to the item you want to reset and tap
the screen.
$FRQ¿UPDWLRQPHVVDJHDSSHDUV

Model menu setting:
5HVHWVDOOWKHIXQFWLRQVLQWKH0RGHOPHQX
H[FHSWFRQGLWLRQVHOHFW
All model setting:
5HVHWVDOO/LQNDJHDQG0RGHOPHQXIXQFWLRQV
H[FHSWIRUIUHTXHQF\PRGHOVHOHFWDQGPRGHOW\SH
Function Name:
$IXQFWLRQQDPHLVUHVHW
Telemetry:
5HVHWWKHWHOHPHWU\VHWWLQJ
[T1-T6 (All condition)]: Resets only the T1-T6 (all
conditions)
[T1-T6(Current and Group condition)]: Resets
only the data of T1-T6 (condition in use and
all the conditions set to group mode)
[Model menu setting]: Resets all the functions
in the model menu, except the condition
selection functions.
[All model setting]: Resets all the functions in
the linkage menu and model menu except
the freTuency, model select, and model
type functions.
[Function name]: Resets only the function
name functions.
[Telemetry]: Resets only the teremetry
functions.
2. Execute reset by tapping the "Yes".
ŏ Select [Data reset] at the linkage menu and call
the setup screen shown below.
CAUTION
ThrottleReverse
■ Onlythethrottlechannel(CH3)initialsetting
isREV(reverse).ThoroughlychecktheHiand
Lowdirectionsoftheengineormotorused
andbecarefulthattheydonotsuddenlyrunat
fullspeed.Evenafterdatareset,CH3isreversed.
CAUTION
NeverengagetheDataresetfunction
whiletheengineisstartingorthemotor
drivewiringisconnected.
■ Sudden,abruptspinningofpropellersorrotors
isextremelydangerous.
ŏReturn to Linkage menu