FUTABA T18SZ - Telemetry: Receiver [Battery]

97
＜ Linkagemenu ＞
Telemetry:Receiver[Battery]
Displaying data from the
receiver battery voltage
,QWKLVVFUHHQWKHEDWWHU\YROWDJHRIDUHFHLYHULV
GLVSOD\HG
,ILWEHFRPHVKLJKHURUORZHUWKDQWKHVHWWLQJDQ
DODUPDQGRUYLEUDWLRQZLOODOHUW\RX
,WFDQQRWEHXVHGLQ)$667PRGHDQG6)+66PRGH
2QO\UHFHLYHUYROWDJHDQG(;7YROWDJHFDQEHXVHGLQ
)$667HVW&+PRGH
7KH)$667HVW&+7)+66PRGHFDQXVHDOOWKHWHOHPHWU\
IXQFWLRQV
Alarm set
1. Tap Alarm and choose from Bu]]er, Voice,
and Inhibit.
2. When not operating vibrator, it is
"
Vibrator" to
Inhibit. Type1-3 will be chosen if it is made to
operate.
3. Tap to the Limit [4.0V] item.
4. Adjust the rate by "ʈʈ" "ʈ" "ʆ" "ʆʆ" button.
Initial value: 4.0V
Adjustment range: 0.0V~100.0V
:KHQWKHVFUHHQLVWDSSHGIRURQHVHFRQGWKHUDWHLVUHVHW
WRWKHLQLWLDOYDOXH
5. To terminate the input and return to the
original state, push the HOME/EXIT button.
Receiverbattery
voltage
Asetupofthe
voltageonwhichthe
alarmoperates.
↓ The"down"arrow
willindicatethatan
alarmwillsoundwhen
thevoltagedropsto
belowthesetting.
Alarmischosenfrom
Buzzer,Voice,and
Inhibit.
TheON/OFFswitch
ofSpeechischosen.
ŏ Tap the [Receiver] button in the Telemetry screen
to call the setup screen shown below.
Max.andmin.values
sincethepower
wasturnedONwill
display.
Type1
Type2
Type3
"Vibrator"type
Ifthefollowingtypesareselected,thetransmitter
willvibrateduringthewarning.
ŏReturn to
Linkage menu