FUTABA T18SZ - Servo Speed

76
＜ Linkagemenu ＞
Servospeed
Sets the speed of each servo.
7KH6HUYRVSHHGVHWWLQJLVXVHGWRVHWWKHVHUYR
GHOD\IRUHDFKFKDQQHOIURPFKDQQHOOWRFKDQQHO
7KHV\VWHPXVHVWKHSURJUDPPHGVSHHGGHOD\
WRVORZGRZQVHUYRSRVLWLRQFKDQJHV7KH6HUYR
Servo speed setting
1. Tap the speed button of the channel you
want to set.
2. Use the value input buttons to adjust the
servo speed.
ŏInitial value: 0
ŏAdjustment range: 0~27 (steps)
VSHHGVHWWLQJFDQEHYDULHGIURPWRLQHDFK
FKDQQHO
ŏ Tap the [Servo speed] button in the Linkage
menu to call the setup screen shown below.
3. Repeat this procedure for each channel.
To close this screen, tap the [Servo speed]
button.
ŏ Tap the [Sub-trim] button in the Linkage menu to
call the setup screen shown below.
Sub-trim
Setting of neutral position of each servo.
7KH6XE7ULPIXQFWLRQLVXVHGWRVHWWKHVHUYR
QHXWUDOSRVLWLRQDQGPD\EHXVHGWRPDNHILQH
DGMXVWPHQWVWRWKHFRQWUROVXUIDFHDIWHUOLQNDJHV
Sub-trim adjustment
1. Tap the trim display part of the channel you
want to adjust.
Value input buttons appears on the Sub-trim
menu screen.
DQGSXVKURGVDUHKRRNHGXS:KHQ\RXEHJLQWRVHW
XSDPRGHOEHVXUHWKDWWKHGLJLWDOWULPVDUHVHWWR
WKHLUFHQWHUSRVLWLRQ
2. Use the value input buttons to adjust the sub
trim.
ŏInitial value: 0
ŏAdjustment range: -240~+240 (steps)
6HHDERYH
3. Repeat this step for each channel.
ŏReturn to Linkage menu
ŏReturn to Linkage menu
（First）0〜27（Slowly）