FUTABA T18SZ User Manual

119
＜ Modelmenu(CommonFunctions) ＞
This section describes the AFR, program mixing,
and other functions common to all model types.
Before setting the model data, use the Model
Type function of the Linkage menu to select the
model type matched to the fuselage. When another
model type is selected thereafter, the AFR, program
mixing, and other setting data are reset.
The functions in the Model menu can be set for
each flight condition. When you want to use the
system by switching the settings for each condition
by switch, stick position, etc., use the Condition
Select function to add flight conditions. (Up to 8
conditions can be used)
Note: The T18SZ is designed so that the airplane and
glider model types are compatible with aircraft of
similar type wings.
This section outlines the relationship between the
functions common to airplanes and gliders, except
some dedicated functions, and model type.
The setting items depend on the number of servos
and other differences according to the wing type
used, but reread them. The setup screens in the
instruction manual are typical examples.
(Model menu screen example)
*The Model menu screen
depends on the model type.
Tapthisiconto
gotothemodel
menu.
ŏ Select the function
name and return to
the Home screen.
ŰƒƇƈƏŃƐƈƑƘŃŋŦƒƐƐƒƑŃƉƘƑƆƗƌƒƑƖŌŃƉƘƑƆƗƌƒƑƖŃƗƄƅƏƈ
[Servo monitor]: Displays the servo test and operation positionĺ/LQNDJHPHQXUHIHUULQJ
[Condition select]: Flight conditions addition, deletion, copy, condition renaming, and condition delay can
be set.
[AFR]: Sets the angle and curve of all the operation functions.
[Dual rate]: D/R curve which can be switched with a switch, etc. can also be added.
[Prog. mixes]: Program mixing which can be freely customized. Up to 10 mixes can be used for each
condition.
MODEL MENU (Common functions)

FUTABA T18SZ Specifications

General

Channels	18
Frequency	2.4GHz
Telemetry	Yes
Modulation	FASSTest, FASST, S-FHSS, T-FHSS
Display	Color LCD
Model Memory	30