144
< Modelmenu(Airplane/Glider/MulticopterFunctions) >
Whenusingthis
function,Tap[INH].
(ONisdisplayed.)
TheON/OFFswitchof
airbrakeischosen.
Thevalueinsidethe
parenthesesshowsthe
currentrudderposition.
Manual/Automode
selection
Manual:Switchesthe
functionON/OFFby
switch
Auto:Airbrakefunction
callcanbelinkedtoa
stick,etc.Astickswitch,
etc.separatefromthe
functionON/OFFswitch
isset.
Offset:Theailerons,
flaps,andelevators
offsetratecanbe
adjusted.Taptothe
correspondingsetting
item.Adjusttherate.
Finetuning:Whenafine
tuningVRissetonthe
nextpage,theailerons',
flaps',andelevators'trim
ratescanbeadjusted.
Taptothecorresponding
settingitem.Adjustthe
rate.
Conditiondelay
settingandcutswitch
setting.
Finetuningsetting
Aileron1
Aileron2
Elevator
Airbrake
This function is used when an air brake is
necessary when landing or diving, etc.
The preset elevators and flaps (camber flap,
brake flap) offset amount can be activated by a
switch.
The offset amount of the aileron, elevator, and
flap servos can be adjusted as needed. Also the
VSHHGRIWKHDLOHURQHOHYDWRUDQGÀDSVHUYRVFDQ
be adjusted. (In side/Out side) A delay can be set
for each condition, and a Cut switch which will
turn OFF the delay can be chosen. Trim amounts
FDQEHILQHWXQHGE\VHWWLQJD95<RXFDQDOVR
set the Auto Mode, which will link Airbrake to a
stick, switch, or dial. A separate stick switch or
dial can also be set as the ON/OFF switch.
ŏ Select [Air brake] at the model menu and call the
setup screen shown below.
*Thedisplayscreenisanexample.Theactual
screendependsontheModelType.
Inspeed
Outspeed
(First)0〜27(Slowly)
Tonextpage
ŏReturn to Model menu