FUTABA T18SZ - Range Check

62
＜ Systemmenu ＞
Battery
Low battery alarm voltage set
*About low battery voltage, all the models included in one
transmitter are changed in common. It cannot set to different
voltage for every model. Moreover, data reset is not carried out.
Select the battery alarm voltage according to the
battery to be used.
Batterytypechange:
LiFe(2cells) → NiMH(5cells)
→ Manualsetting
Itisn'tindicatedincase
ofmanualsetting.
VibratorTypes
Type1
Type2
Type3
Auto power off time setting
This function prevents battery
discharging if the transmitter power
supply does not erase.
1. Adjust the auto power off time with
the value input buttons.
*When the time the transmitter is inactive reaches
the set time, the power is turned off automatically.
This time can be set up to 1 hour in 10 minutes
increments. The auto power off function can also
be deactivated.
*An audible alarm is sounded from 3 minutes
before auto power off. When a stick or switch is
operated while the alarm is cleared.
RefertoP.46
RangeCheck
Before a Áight ground range check.
The 'range check mode' reduces the transmission
range of the radio waves to allow for a ground
range check.
*The range check mode, when activated, will continue for
60 seconds unless the user exits this mode early. When the
progress bar reaches 60 second mark, the RF transmission
automatically

returns to the normal operating power.
WARNING
Donotflyintherangecheck
mode.
*Sincetherangeoftheradiowavesis
short,ifthemodelistoofarfromthe
transmitter,controlwillbelostandthe
modelwillcrash.
ŏReturn to System menu
Whenchoosingmanual
setting,thenumerical
valuecanbeinput.
It'sdangerousto
setitmanuallyin
thelowvoltage.