FUTABA T18SZ - Telemetry: RPM Sensor

100
＜ Linkagemenu ＞
rpm
Asetupoftherpm
onwhichthealarm
operates.
↑Anupwardarrow
willshowthatanalarm
willsoundwhenthe
rpmrisesabovetheset
value.
↓Adownwardarrow
willshowthatanalarm
willsoundwhenthe
rpmfallsbelowtheset
value.
Alarmischosenfrom
Buzzer,Voice,and
Inhibit.
TheON/OFFswitch
ofSpeechischosen.
ŏ Tap the [rpm sensor] button in the Telemetry screen
to call the setup screen shown below.
Max.andmin.values
sincethepower
wasturnedONwill
display.
,WFDQQRWEHXVHGLQ)$667PRGHDQG6)+66PRGH
2QO\UHFHLYHUYROWDJHDQG(;7YROWDJHFDQEHXVHGLQ
)$667HVW&+PRGH
7KH)$667HVW&+7)+66PRGHFDQXVHDOOWKHWHOHPHWU\
IXQFWLRQV
Type1
Type2
Type3
"Vibrator"type
Ifthefollowingtypesareselected,thetransmitter
willvibrateduringthewarning.
Telemetry:RPMSensor
Displaying data from the rpm
7KH5306HQVRUVFUHHQLVXVHGWRVHWXSDQ
RSWLRQDOUSPVHQVRUDQGGLVSOD\WKHURWDWLRQ
LQIRUPDWLRQLWWUDQVPLWV
7KHURWDWLRQRIWKHPRGHOHQJLQHPRWRUHWF
ZKLFKLVÀ\LQJFDQEHVKRZQ
,ILWEHFRPHVKLJKHURUORZHUWKDQWKHVHWWLQJDQ
DODUPDQGRUYLEUDWLRQZLOODOHUW\RX
Alarm set : Over
（
Under
）
rotations
1. Tap Alarm and choose from Bu]]er, Voice,
and Inhibit.
2. When not operating vibrator, it is
"
Vibrator" to
Inhibit. Type1-3 will be chosen if it is made to
operate.
3. Tap to the Limit [
xxx
rpm] item .
4. Adjust the rate by "ʈʈ" "ʈ" "ʆ" "ʆʆ" button.
Initial value: Ń 2,000rpm Ņ 0rpm
Adjustment range: 0rpm~150,000rpm
(ŃLimit
≧
ŅLimit)
:KHQWKHVFUHHQLVWDSSHGIRURQHVHFRQGWKHUDWHLVUHVHW
WRWKHLQLWLDOYDOXH
5. To terminate the input and return to the
original state, push the HOME/EXIT button.
*Arpmsensormustbeinstalledintheaircraft.
"Magnet"
"Optics"
"Brushlessmotor"
SBS-01RM→
SBS-01RO →
SBS-01RB→
Gearratio
Blade
Pole
1.00~99.00
2~10
2~30
ŏReturn to
Linkage menu