FUTABA T18SZ User Manual

75
＜ Linkagemenu ＞
Tapthevaluesyou
wishtoadjustand
valueinputbuttons
willappearon-screen.
Travelrate Limitpoint
Nextpage
7-16Ch
Left/Top Right/Bottom
30 〜
140%
30 〜
140%
Indicatesthecurrent
directionofthestick,etc.
ŏ Tap the [End point] button in the
Linkage menu to call the setup
screen shown below.
Endpoint
Sets the travel, limit point.
(Thedisplayscreenisanexample.Thescreendependsonthemodeltype.)
7KH(QGSRLQWIXQFWLRQDGMXVWVWKHOHIWDQGULJKW
VHUYRWKURZVJHQHUDWHVGLIIHUHQWLDOWKURZVDQG
ZLOOFRUUHFWLPSURSHUOLQNDJHVHWWLQJV
7KHWUDYHOUDWHQRUPDOIXOOVWLFNPRYHPHQWDW
KLJKUDWHVFDQEHYDULHGIURPWRLQ
HDFKGLUHFWLRQRQFKDQQHOVWR$OVRWKHOLPLW
SRLQWKRZIDUWKHVHUYRWUDYHOVZKHQDPL[LV
LQYROYHGZKHUHVHUYRWKURZVWRSVPD\EHYDULHG
IURPWR
Servo travel adjustment
1. Tap the travel button of the channel you
want to set. Value input buttons appear on
the screen.
2. Use these buttons to adjust the rate.
ŏInitial value: 100
ŏAdjustment range: 30~140
3. Repeat the procedure above for each rate.
Limit point adjustment
1. Tap the limit button of the channel you want
to set.
2. Use the value input buttons to adjust the limit
point.
ŏInitial value: 135
ŏAdjustment range: 0~155
3. Repeat this procedure for each limit point.
ŏReturn to
Linkage menu

FUTABA T18SZ Specifications

General

Channels	18
Frequency	2.4GHz
Telemetry	Yes
Modulation	FASSTest, FASST, S-FHSS, T-FHSS
Display	Color LCD
Model Memory	30