FUTABA T18SZ - Page 77

77
＜ Linkagemenu ＞
ŏ Tap the [Function] button in the Linkage menu
to call the setup screen shown below.
Function
Channel assignment for each function can be changed to suit your needs.
:KHQ\RXVHOHFWPRGHODQGZLQJVZDVKW\SHV
\RXZLOOILQGWKDWWKHRSWLPL]HGFRPELQDWLRQVRI
VHUYRRXWSXWFKDQQHOVDQGIXQFWLRQVKDYHEHHQ
DOUHDG\SUHVHW,I\RXZRXOGOLNHRQWKHIXQFWLRQ
VHWWLQJVFUHHQRIWKHOLQNDJHPHQX\RXFDQIUHHO\
FKDQJHFRPELQDWLRQVRIVHUYRRXWSXWFKDQQHOV
IXQFWLRQVDLOHURQHOHYDWRUHWFDQGLQSXW
FRQWUROOHUVVWLFNVVZLWFKHVWULPOHYHUVDQGWULP
VZLWFKHV<RXFDQDOVRDVVLJQWKHVDPHIXQFWLRQWR
PXOWLSOHVHUYRRXWSXWFKDQQHOVVXFKDVDVVLJQLQJ
HOHYDWRUIXQFWLRQWR&+DQG&+
Function change
1. Tap the function button of the channel you
want to change to call the Function select.
2. Select the function you want to change.
DG1, DG2 (switch channels)
7KHVHWZRFKDQQHOVFDQEHXVHGDVVZLWFK2Q
2IIFKDQQHOV<RXFDQIUHHO\FKDQJHFRPELQDWLRQV
EHWZHHQVHUYRRXWSXWFKDQQHOVDQGLQSXWFRQWUROOHUV
VWLFNVVZLWFKHVWULPOHYHUVDQGWULPVZLWFKHV
Channel restrictions by a System Type
)$667HVW&+&+6ZLWFK
)$667HVW&+&+6ZLWFK
)$66708/7,&+6ZLWFK
)$667&+&+
6)+66&+
7)+66&+6ZLWFK
Operation control change
1. Tap the control button of the channel you
want to change. A control select screen
(stick, switch, knob, trim lever, etc.) is
displayed.
2. Select the control you want to operate.
7KHVDPHFRQWUROFDQEHDVVLJQHGWRPXOWLSOHFKDQQHOV
ŏReturn to
Linkage menu