FUTABA T18SZ - Page 104

104
＜ Linkagemenu ＞
Telemetry:Voltage[Ext.battery]
Alarm set
1. Tap Alarm and choose from Bu]]er, Voice,
and Inhibit.
2. When not operating vibrator, it is
"
Vibrator" to
Inhibit. Type1-3 will be chosen if it is made to
operate.
3. Tap Limit [4.0V].
4. Adjust the rate by "ʈʈ" "ʈ" "ʆ" "ʆʆ" button.
Initial value: 4.0V
Adjustment range: 0.0V~100.0V
:KHQWKHVFUHHQLVWDSSHGIRURQHVHFRQGWKHUDWHLVUHVHWWR
WKHLQLWLDOYDOXH
5. To terminate the input and return to the
original state, push the HOME/EXIT button.
Asetupofthe
voltageonwhichthe
alarmoperates.
↓ The"down"arrow
willindicatethatan
alarmwillsoundwhen
thevoltagedropsto
belowthesetting.
Alarmischosenfrom
Buzzer,Voice,and
Inhibit.
TheON/OFFswitch
ofSpeechischosen.
ŏ Tap the [Voltage] button in the Telemetry screen to
call the setup screen shown below.
Max.andmin.values
sincethepower
wasturnedONwill
display.
Type1
Type2
Type3
"Vibrator"type
Ifthefollowingtypesareselected,thetransmitter
willvibrateduringthewarning.
Displaying data from the EXT
battery voltage port
,QWKLVVFUHHQWKH(;7EDWWHU\YROWDJHLV
GLVSOD\HG,QRUGHUWRXVHWKLVIXQFWLRQLWLV
QHFHVVDU\WRFRQQHFW([WHUQDOYROWDJHFRQQHFWRURI
56%
⇔
6%69
⇔
%DWWHU\
6%69PHDVXUHVWZREDWWHULHV7KHSRZHU
EDWWHU\FRQQHFWHGWRWZROLQHVLVGLVSOD\HGRQ(;7
92/7
*SBS-01Vmustbeinstalledintheaircraft.
,WFDQQRWEHXVHGLQ)$667PRGHDQG6)+66PRGH
2QO\UHFHLYHUYROWDJHDQG(;7YROWDJHFDQEHXVHGLQ
)$667HVW&+PRGH
7KH)$667HVW&+7)+66PRGHFDQXVHDOOWKHWHOHPHWU\
IXQFWLRQV
Ext.battery
voltage
ŏReturn to
Linkage menu