FUTABA T18SZ - Page 127

127
＜ Modelmenu(Airplane/Glider/MulticopterFunctions) ＞
AIL3
(ChipAileron)
AIL4
(ChipAileron)
AIL1
(MainAileron)
AIL2
(MainAileron)
FLP2
(CamberFlap)
FLP1
(CamberFlap)
ELEVATOR
(ELEVATOR2)
V-TAIL AILVATOR
FLP3
AIRBRAKE
(BrakeFlap)
FLP4
(BrakeFlap)
RUDDER2
Winglet
RUDDER1
RUDDER
(RUDDER2)
Winglet
atFlyingwing atFlyingwing
()
()
ELEVATOR
ELEVATOR2
(AILERON5)
(AILERON6)
Camber mixing
This mix adjusts the camber and corrects the
elevators. [Airplane/glider, 2 ailerons or more]
$LUEUDNHĺ(/(
This mix is used to correct operation of the airbrakes
(spoilers) when landing. [Airplane/glider, general]
&DPEHUÀDSĺ(/(
This mix is used to correct for attitude changes when
the camber flaps are being used. [Airplane/glider, 2
DLOHURQVÀDSRUPRUH@
5XGGHUĺ$LOHURQ
This function is used to correct roll knife edge, etc.
of stunt planes. [Airplane/glider, general]
5XGGHUĺ(OHYDWRU
This function is used to correct roll maneuvers, knife
edge, etc. of stunt planes. [Airplane, general]
%XWWHUÀ\&URZ
This function is used when powerful brake operation
is necessary. [Glider, 2 ailerons or more]
Trim mix 1/2
The ailerons, elevators, and flaps trim offset rate
can be called by switch or condition selection. [Glider
general]
Snap roll
This function selects the snap roll switch and adjusts
the steering angle of each rudder. Servo speed can also
be adjusted. [Airplane general]
$LUEUDNH
This function is used when airbrakes are necessary
when landing or when diving, etc. during flight.
[Airplane, general]
*\UR
This is a dedicated mix when a GYA Series gyro is
used. [Airplane/glider/multicopter, general]
Ailevator
This function adjusts the elevators and ailerons of
models with elevator specifications. [Airplane/glider,
HOHYDWRUVSHFL¿FDWLRQV@
Acceleration
Allows a brief "overload" in response to sudden
(OHYDWRU(OHYDWRUĺ&DPEHUDQG$LOĺ5XGGHU>*OLGHU
general]
Motor
The operation speed when the motor of F5B
and other EP gliders is started by switch can be set.
[Airplane/glider, general]
V-Tail
This function adjusts the elevators and rudder of
9WDLOPRGHOV>$LUSODQHJOLGHU9WDLOVSHFL¿FDWLRQV@
Winglet
This function adjusts the left and right rudders of
ZLQJOHWPRGHOV>$LUSODQHJOLGHUZLQJOHWVSHFL¿FDWLRQV@