FUTABA T18SZ - Page 162

162
＜ ModelMenu(HelicopterFunctions) ＞
Pitch → Needle
This mixing is used when the engine is equipped
with needle control or other fuel-air mixture
adjustment. A needle curve can be set.
An acceleration function which temporarily
increases needle operation at throttle stick
Setting method
ŏ When using this function, Tap [INH]. (ON is
displayed.)
ŏ When you want to set the same contents at
other conditions, select the group mode.
When you want to set the selected condition
only, select the single mode (initial setting).
ŏ A needle curve can be set.
ŏ A switch can be set.
When [--] is set, the mixing function is
operated by merely selecting the condition.
When setting an [ON]/[OFF] switch, tap
to the [--] item. Tap the screen to call the
selection screen and set the switch and its
ON position.
< Acceleration function setting>
ŏAcceleration can be set at both setting
at acceleration (high) and setting at
deceleration (low).
ŏThe acceleration rate (rate) and the return
time after operation (damping) can be set.
ŏAn operation point (Act position) at
acceleration and deceleration can be set.
When an operation point was exceeded,
acceleration operation is performed.
ŏ Select [PitchńNeedle] at the model menu and
call the setup screen shown below.
acceleration/deceleration operation can be set.
The rise characteristic of the needle servo at
acceleration and deceleration operation can be
adjusted.
●Mixingcurvesetting
*Foradescriptionofthe
curvesettingmethod,
seethedescriptionat
thebackofthismanual.
Normally,use[Point]type.
ŏReturn to Model menu