G&D CATVision - Set System Defaults; Remote Video (Dark-Switching)

Guntermann & Drunck GmbH Operating Instructions
CATVision (MC)
6.2.2.3 Set System Defaults (Supervisor Function)
This function sets back this device to the default condition.
Also the passwords and IVT settings are set back.
The corresponding default settings can be found in the descriptions of the
different menu windows in this documentation.
Move with the cursor control keys to the corresponding menu.
By pressing ENTER the function will be executed and the following window will
open.
Info CVM
This function will delete
all settings.
Press Enter to continue
or
Esc to cancel
Confirm again with ENTER. The window will change to the menu FUNCTION.
6.2.2.4 Remote Video (Dark-Switching)
With this setting you define whether the monitor of the remote console at
keyboard or mouse action of the local console either
 stays permanently visible or
 is switched dark.
The following selections are possible:
 ON: Monitor stays permanently visible
 Switch off: Monitor is switched dark at keyboard or mouse action of
the local console.
For saving the settings and closing the menu press F1.
You can always close this menu by pressing ESC.
page 38