Guntermann & Drunck GmbH Operating Instructions
CATVision (MC)
5.4.4.1 Changing video channels
This function is only with CATVision-MC-Systemen available.
IVT
Active channel: 1
CVM
The entry “active channel” refers to the corresponding used video channel.
The channels can be selected via pressing the keys 1 to 4.
Confirm with ENTER.
5.4.4.2 Automatic Settings
You can establish all video settings automatically. To do so, you must be
connected to a target.
To activate this function, press the F5 key. While the settings for the active
channel are being established automatically, the monitor turns black for approx.
3 seconds.
With the F6 key the settings will be established for all channels (only with
CATVision-MC systems). In this case, following message appears on your
monitor:
Info CVM
Automatic Video Tuning
status
Channel 1: ok
Channel 2: not connected
Channel 3: in progress
Channel 4: wait
Please wait
Whilst the automatic measuring this windows informs you about the process of
the respective measurement.
page 23
To Next Page
Loading...
