GCC Technologies AFR-24S - Chapter 5: Automatic-Aligning System (AAS II); AAS II System Introduction

AFR-24S User Manual
101
Chapter 5 Automatic-Aligning System
Please note that this chapter is only an instruction to AASII; for step-by-step instructions,
please refer to the following chapters: A-4 CorelDRAW Plug-in , A-5 Illustrator Plug-In, A-6
GreatCut Plug-In.
5.1 Introduction
The RX II series cutting plotters feature a standard Automatic-Aligning System (AAS II) to
guarantee precise contour cutting quality by detecting the registration marks printed around
the graphic.
Notice
 Avoid any kind of light source horizontally illuminating the AAS module.
- PROHIBITED - ACCEPTABLE
 DO NOT take off the cover of AAS module while in operation.
- PROHIBITED