GCC Technologies AFR-24S - Page 66

AFR-24S User Manual
66
Cancel Restore
Change: OK: ENTER
Sure to Restore
Change: OK: ENTER
Offline For System Setup
OverCut: 0.00~1.00mm with an
increment of 0.05mm
[ TOOL SELECT]
Pouncing: 0~200mm with an
increment of 1mm
[ MISC]
Enabled, Disabled
Enabled, Disabled
Select from 1S to 4S
Unrolled 500~3000mm
Slow, Normal, Fast
USER Defined, Default
EDGE, Default ROLL
Forward Direction, Auto
Direction, Reverse Direction
±40mm with an increment of 0.5mm
Rear Paper Sensor
Select: OK:ENTER
Auto Unrolled Length
Select: OK:ENTER
Auto Unrolled Speed
Select: OK:ENTER
Adjust Paper
Select: OK:ENTER
OverCut: 0.00mm
Select: OK:ENTER
Pouncing 0 mm
Select: OK:ENTER
1S:72 F:80 O:0.275 M
Select: OK:ENTER
Set Smoothing Cut
Select: OK:ENTER
Set Tangential Mode
Select: OK:ENTER
Panel Setup
Select: OK:ENTER
Factory Default ?
Select: OK:ENTER
Auto Unrolled Media
Select: OK:ENTER
Vacuum
Select: OK:ENTER
First Back To Origin
Select: OK:ENTER
AAS Copy
Select: OK:ENTER
Paper Saving Mode
Select: OK:ENTER
Scale Length
Select: OK:ENTER
Scale Width
Select: OK:ENTER
Sizing Setting
Select: OK:ENTER
Pen_Blade Offset
Select: OK:ENTER
Graph Start atM
X: Y:
Switch of Pen
Please Wait……
Switch of Cutter
Please Wait……
Pen overlap Cut
X: Y:
Redo P-B Offset Test
N: ONLINE OK:ENTER
AAS Offset
Select: OK:ENTER
AAS Detect Mode
Select: OK:ENTER
AAS Ext. Offset
Select: OK:ENTER
X, Y:
-10.000~10.0
00
Enabled, Disabled
Enabled, Disabled