ActionStep
Remove the protective end cap from
inlet tube 5 (arrow), and connect the
test solution.
Note:
If ÄKTA ready gradient is installed use
inlet tube 7.
2
Remove the protective end cap from
outlet 6 (arrow), and connect a waste
hose to this outlet.
3
WARNING
Over-pressure. Never block the outlet tubing with, for instance,
stop plugs, since this will create over-pressure and might result in
injury.
110 ÄKTA ready Operating Instructions 28960345 AD
8 Component test
8.1 Run a component test
To Next Page
Loading...
