ActionStep
Conductivity cell:
Unscrew the protective cap (1)
on the system cabinet´s conduc-
tivity connector.
4 A
Connect the conductivity sensor
by screwing its cable connector
(2) onto the connector on the
system cabinet.
4 B
Note:
Before inserting the connector, make sure it is correctly positioned. There is
a small ridge on the male connector and a corresponding groove on the female
connector. Do not use force when inserting the connector.
ÄKTA ready Operating Instructions 28960345 AD 93
6 Flow kit installation
6.3 Mounting the flow kit
To Next Page
Loading...
