GE Invenia ABUS 2.0

System Setup
3-46 Invenia ABUS 2.0 – System Setup and Basic Service Manual
4700-0043-00 Rev. 4
Setting up the Invenia ABUS 2.0
Powering on the device
1. Connect the power cord to the system and to the room’s AC
outlet.
2. Connect the network cable (located on the rear panel) to the
system and to the room’s Ethernet connection.
3. Power up the system.See ‘Switch ON the AC Power to
Invenia ABUS 2.0’ on page 3-45.
Logging in as Admin
1. Login with your Service Account.
a. Type Admin.
b. Enter your password.
When the system boots up from the Service Login, three
icons appear in the bottom, right corner of the Touch
Screen.
• Minimize: minimizes the Invenia ABUS 2.0 application
software to display the Windows desktop. This icon is
available only with the Service login.
• Configuration (gears): displays the configuration
screens.
• Exit: closes the application software.
Figure 3-6. Service icons