GE MEDICAL SYSTEMS
D
IRECTION 2300000, REVISION 2 LOGIQ™5 SERVICE MANUAL
Chapter 8 Replacement Procedures 8-171
8-10-5-3 Saving Connectivity
Before starting upgrade, write down
the Connectivity Setting for back-up.
1.) Touch Utility > Connectivity on the touch panel and click the Tcpip tab.
2.) Write down the following parameters:
Parameters Descriptions (Entry for Stand-Alone System)
Computer Name
Enable DHCP
IP-Address
Subnet Mask
Default Gateway
Remote Archive IP-Addr
Remote Archive Name
Note : For a stand-alone system, preset values of IP address, subnet mask, and default gateway, shown
above, must entered.
Figure 8-201 Connectivity
To Next Page
Loading...
