GE PACSystems RX3i - Page 23

`
help
GFK-2572 Chapter 2 Monitor Level Commands 2-7
2
Displaying Parameters for a Command
This example shows the use of ? to display the parameters for the Show command..
Screen Display
device-name> show ?
arp - Show ARP table
config - Show Configuration items
icmp - Show ICMP status and/or counters
ip - Show IP status and/or counters
log - Show local log table
mac - Show active and non-volatile MAC addresses
mem - Show System Memory status and/or counters
network - Show Network Interface status and/or counters
node - Show Identification, Status and Module Info
port - Show Ethernet port info
profinet - Show PROFINET status and/or counters
rdnMedia - Show Media redundancy status and/or counters
sessionTimeout - Show session inactivity timeout value
sm - Show shared memory status and/or counter
tcp - Show TCP server status and/or counters
telnetd - Show whether telnet is enabled or disabled
time - Show internal module clock
udp - Show UDP status and/or counters
device-name>