om 5184516-100 Rev. 5 2-19
OPERATIONAL CHECKS
Be sure the equipment is functioning properly and safely before each exam-
ination:
Verify that the following controls are operating correctly:
• Motion Controls, and Lock Releases.
• Audible and visual alarms.
Visually inspect the equipment and make sure that:
• Equipment is not damaged or missing parts.
• All cover panels are in place prior to turning on electrical power (hazard-
ous electrical or mechanical parts could be exposed.
APPROVED OPERATING PROCEDURES AND ACCESSORIES
Be sure to use the equipment and the equipment and the approved accesso-
ries according to approved operating procedures:
• Perform X–ray tube warm up procedures prior to the exam. Failure to per-
form this procedure could damage the X–ray tube assembly.
• Do not exceed tabletop rating of a 136 kg (300 lbs.) patient. Excessive
loading could damage the tabletop and/or cause the patient to fall.
• Accessories should be properly attached to the table and positioned so as
not to interfere with system motions.
• Avoid unnecessary exposure to radiation. Stay behind the lead glass radi-
ation shield or lead screen. When in unshielded areas, wear protective
apparel such as goggles, lead aprons, and gloves.
PLANNED MAINTENANCE
POSSIBLE PATIENT OR OPERATOR INJURY!
TO AVOID POSSIBLE PATIENT OR OPERATOR INJURY, BE SURE TO
PERFORM PERIODIC INSPECTIONS AND MAINTENANCE PROVIDED
IN THIS DOCUMENT. FAILURE TO PERFORM THESE INSPECTIONS
COULD ALLOW DETERIORATING CONDITIONS TO DEVELOP
WITHOUT BEING DETECTED. THIS DETERIORATION COULD RESULT
IN EQUIPMENT FAILURES WHICH COULD CAUSE SERIOUS INJURY
AND EQUIPMENT DAMAGE.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
Need help?
General
