EasyManuals Logo

GE Precision 500D User Manual

GE Precision 500D
323 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
om 5184516-100 Rev. 5 2-20
RADIATION SAFETY
Always use proper technique factors for each procedure to minimize x–ray expo-
sure and to produce the best diagnostic results. In particular, you must be thor-
oughly familiar with safety precautions before operating the system.
It is not always possible to determine when some components, such as x–ray
tubes, are nearing the end of their operating lives. These components could stop
operating during a patient examination.
Use radiation protection when using this equipment. Gonadal shielding and lead
aprons are essential to provide radiation protection for the patient and the operator.
KNOW THE EQUIPMENT
Read and understand all the instructions in the operating manuals before attempt-
ing to use the product and request training assistance from GE Medical System if
needed. Keep operating manuals with the equipment at all times and periodically
review the procedures and safety precautions.
This system contains operating safeguards to provide maximum safety. Before
calling for service, be certain proper operating procedures are being used.
Satisfactory equipment performance requires the use of service personnel specially
trained on x–ray apparatus. GE Medical Systems is responsible for the effects on
safety, reliability, and performance only if the following conditions are met:
The electrical wiring of the relevant rooms complies with all national and
local codes as well as the Regulations for the Electrical Equipment of
Buildings published by the Institution of Electrical Engineers.
All assembly operations, extensions, re–adjustments, modifications or
repairs are carried out by GE Medical Systems’ authorized service repre-
sentatives.
5-2Electrical Safety
If the table is to be used for special procedure applications, a grounding kit is
required and can be factory installed with original order.
WHEN THE SPOT FILM DEVICE TOWER IS POSITIONED AS FAR
TOWARDS THE BACK OF THE TABLE AS POSSIBLE AND THE TABLE
TOP IS POSITIONED AS FAR TOWARDS THE FRONT OF THE TABLE
AS POSSIBLE, A PORTION OF THE METAL FRAMEWORK OF THE
TABLE WILL BE VISIBLE IN THE IMAGE. A PORTION OF THE X–RAY
IMAGE WILL BE CUT OFF WITH THE SPOT FILM DEVICE TOWER AND
THE TABLE TOP IN THESE EXTREME AND OPPOSING POSITIONS.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE Precision 500D and is the answer not in the manual?

GE Precision 500D Specifications

General IconGeneral
BrandGE
ModelPrecision 500D
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals