GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
3-42 Section 3-7 - Completing the Hardware Installation
5.) Connect the USB cable located on the SafeLock Cart main column, into the USB port located at the
rear of the Vivid q N system (Figure 3-31 on page 3-39).
6.) Re-connect power to the SafeLock Cart and to the Vivid q N system.
7.) Switch on the circuit breaker and turn ON power to the Vivid q N system.
8.) Perform the following test:
a.) Insert a CD-R disk in the DVD/CD-RW Drive.
b.) Eject and remove the CD-R disk to check the eject mechanism functions properly.
To Next Page
Loading...
