GE Vivid q N - Diagnostic Test Window Menu Options

GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
7-10 Section 7-2 - Diagnostics
7-2-4 Diagnostic Test Window Menu Options
The Diagnostic Test menu includes the options described below.
7-2-4-1 Full System Test
NOTE: The Full System Test requires approximately 10 minutes for completion.
7-2-4-1-1 Full System Test (FE and BEP)
Performs a full sequence of complete Front End and Back End tests (automatically) that do not require
user intervention. This is particularly recommended for detecting problems that are intermittent in
nature, since a test may be paused at any stage and any detected failures reviewed.
For test procedure instructions, see the Full System Test (FE and BEP) section, on page 7-20.