GE Vivid q N - TR32 and RFI Boards Replacement Procedure

GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
8-32 Section 8-3 - Internal Component Replacement Procedures
8-3-2 TR32 and RFI Boards Replacement Procedure
NOTE: When installing TR32 Boards V12 in systems running BT09 software, after installation ACW Diagnostic
Test Results will display erroneously as “Failed”.
NOTE: When replacing the TR32 Boards, both boards must be of the same version. (A TR32 Board
V12 cannot be used with a TR32 Board V7). Always verify this by examining the version number
stated on the board, as shown in Figure 8-34, below.
NOTE: Before installing the TR32-V12 board, check that the DCDC V4 board (P/N 2403248-4) is
already installed. Always verify this by examining the Power Supply DCDC Board version
number stated in the About Screen (HwVersion tab), as shown in Figure 8-35, below. If the
DCDC V2 is installed, replace it with the DCDC V4 board.
Figure 8-34 TR32 Board Verification (Version 12)
Figure 8-35 DCDC Board Verification (Version 4)
TR32 Board
Version (V12)
Verification
DCDC Board
Version (V4)
Verification