GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
8-114 Section 8-5 - Software Loading
8-5-2 Setting the BIOS
NOTE: This procedure is applicable to both MODBR949 and MODBR929 versions.
1) While booting, press F2 “Config / Diag” on alphanumeric keyboard
2.) Type the password “marlin04”.
3.) Exit and save presets.
4.) Select <Exit> section and load “Setup Defaults”.
5.) Select <Main> section.
6.) Set correct System Time and System Date. Set Date using next format MM/DD/YYYY
7.) Check that IDE Primary Master is detected.
8.) Proceed to "Setting the BIOS Advanced Parameters" on page 8-115.
Figure 8-114 BIOS Main Tab
To Next Page
Loading...
