GE Vivid q N - Page 179

GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
Chapter 3 - System Setup 3-107
The Local Area Connection Properties dialog box opens.
8) Select Internet Protocol (TCP/IP).
9) Click the Properties button.
The Internet Protocol (TCP/IP) Properties dialog box opens.
10.)Activate the Use the following IP address check box.
11.)Type in the Vivid q N IP address 10.0.0.1 or the one provided by the local network administrator.
NOTE: The IP must be different from the IP address used for network computer.
12.)Type in the Subnet mask 255.255.255.0 or the one provided by the local network administrator.
NOTE: The Subnet mask should be the same for both the network computer and the
VividqN.
13.)Click OK
14.)Press the Config button on the control panel to close all windows and return to the regular scanning
mode.
Figure 3-111 Local Area Connection Properties
Figure 3-112 Internet Protocol (TCP/IP) Properties