GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
Chapter 3 - System Setup 3-135
2.) Type the patient’s Last Name and ID in the appropriate fields (see Figure 3-142).
3.) Select the Dataflow you intend to use for this patient’s information (in this case, select Local
Archive – Int HD/eVue as shown in Figure 3-142).
4.) Using the soft key buttons, select CREATE PATIENT
.
5.) Now start scanning. Each image you would like to store press the STORE
button.
A few seconds after the Store button is pressed, images will be transferred into the remote
computer (which was previously set as the destination - refer to Figure 3-141 on page 3-133).
6.) To proceed, follow to the instructions as described for "Using MPEGVue Viewer on a Remote PC"
on page 3-152.
To Next Page
Loading...
