GE Vivid q N - Page 277

GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
Chapter 4 - General Procedures and Functional Checks 4-23
4-3-1-6 CW Test
4-3-1-7 Visual Test
Table 4-10 CW Test - Recommended
Step Task Expected Result(s)
1
Boot-up the System in Regular Scanning Mode
2
Press Alt + Config to enter Diagnostics Mode
3
From the Diagnostic Test tree, select Front End Test.
4
Run Full System Test and press Start PASS
5
Connect the 3S-RS probe to the probe port.
6
From the Diagnostic Test tree, select Front End Test.
7
Select TR32 then select TX. Select TXProbeTX Test
and press Start
PASS
8
Select MUX Test then select 3S-RS Test and press
Start
PASS
9
Select TR32 Test then select RX Test. Select RSTest
with 3S-RS and press Start
PASS
10
When done, press the Esc button
Table 4-11 Visual Test - Recommended
Step Task Expected Result(s)
1
Insert 3S-RS probe.
2
Increase the gain to see the homogenous noise.
The probe ID is 3S-RS. No strikes or artefacts are
present.