GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
Chapter 7 - Diagnostics/Troubleshooting 7-7
Reports
Displays the specific report (or list of reports) for the
currently-selected test sequence.
(shows all OK and failed tests)
Certain tests will have more than one report (see the
example in Figure 7-3 below).
Double-clicking on a currently-selected
report displays that report in the Report
window (lower portion of the View Log
dialog box) - refer to Figure 7-4 below.
Reports Scroll
Bar and Arrows
Enables scrolling through the list of Reports
A test sequence may have up to four
reports. Since only one specific test may
have failed, the scroll arrows enable
jumping directly from one Failed test
report to the next (i.e., failures only).
Alternatively, you can scroll through all the
reports (one-by-one).
Erase Button
Clears all test sequence log files for that specific
(currently selected) test listed in the Tests window
(passed and failed tests).
It is not recommended to clear the test
sequence log files unless a test failed due
to user intervention or as a result of a false
alarm. (It is necessary to erase each log
file separately).
Exit Button Closes the View Log dialog box
Returns to the Diagnostic Test window.
Report Window
Lower portion of the View Log dialog box where the
currently-selected report is displayed in a separate window
(see the example in Figure 7-3).
The displayed Average, Deviation, Max and Min values
are dynamically updated.
Visible only after test execution.
Report window
Scroll Arrows
Enables scrolling through all channels.
Displays the currently-selected channel number. For
example, Count: 64
Close Button Closes the Report window.
Table 7-3 Vivid q N Diagnostics Test Window - View Log (cont’d) 2 of 2
Option Description Comments
Scroll between
reports here
Jump to Failed Test Reports
To Next Page
Loading...
