GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-9
The following screen displays:
7.) Select “Y” to continue with the formatting process or “N” to restart the procedure.
The system will start the formatting procedure and reboot automatically.
After rebooting, the system will boot from the software installation CD.
8.) Perform a “Full Clean Install” software procedure corresponding to the BT level of your system.
- Refer to the "Software Upgrade Procedure Overview" on page 8-99
Note: IMPORTANT - if both the Hard Disk and Back End are being replaced simultaneously, it is
necessary to re-configure the LCD type.
9.) When done, proceed to perform the following functionality tests:
- "Software Configuration Checks" on page 4-39
- "Calibration Tests" on page 7-25
- "Full System Test" on page 7-10
10.)After you have completed the formatting procedure, store the Formatting Utility Disk at the
customer’s site where it can be accessed for future use.
To Next Page
Loading...
