GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-83
8-4-10-4 USB Board Installation Procedure
1) Return the replacement USB board to its position on the SafeLock Cart chassis and secure it with
the upper and lower bolts previously removed - see Figure 8-98.
2) Reconnect the P6 cable to the P6 connector on the USB board.
3) Reconnect the USB cable to the USB board.
4.) Return the Upper Cover (Rear), as described in the "Upper Cover (Rear) Installation Procedure" on
page 8-66.
5.) Reconnect the AC power cable to the AC input assembly at the base of the cart (rear) and turn ON
power to the SafeLock Cart.
6) Proceed to perform the following functionality tests:
- "SafeLock Cart - Grounding Continuity" on page 10-22
- "SafeLock Cart - Chassis Current Leakage Test" on page 10-24
To Next Page
Loading...
